Eiki LC-XT4 Owner's Instruction Manual page 41

Remote control
This projector provides eight different remote control codes (Code
1-Code 8); the factory-set, initial code (Code 1) and the other
seven codes (Code 2 to Code 8). This switching function prevents
remote control interference when operating several projectors or
video equipment at the same time.
For example operating the projector in "Code 7", both the projector
and the remote control must be switched to "Code 7".
To change the code for the projector;
Select a remote control code in this Setting Menu.
To change the code for the remote control;
Check the Reset Switch to "Use position" in the compartment lid
on back of the remote control.
And then while holding down the MENU button, press the IMAGE
button number of times corresponding to the remote control code
for the projector.
To reset the code for the remote control;
Slide the Reset Switch to "Reset position" in the compartment lid
on back of the remote control.
On start
When this function is "On," projector is automatically turned on just
by switching MAIN ON/OFF SWITCH on.
Note ; Be sure to turn projector off properly (refer to section
"TURNING OFF PROJECTOR" on P23). If projector is turned
off in wrong steps, On Start function does not operate
properly.
Lamp counter reset
This function is used to reset the lamp replace counter. When
replacing the projection lamp, reset the lamp replace counter
by using this function. See page 45 for operation.
Factory default
This function returns all setting values except the lamp
counter to the factory default settings.
Quit
Closes SETTING MENU.
Remote control
When pressing the SELECT
button at Remote control, the
remote control code menu
appears.
Reset position
Use position
Reset switch
Select Factory default and this
Factory default
box appears. Select [Yes], and
the next box appears.
Select [Yes] to activate it.
SETTING
41