HoMedics spa REFLECTIVES M-6011 Instruction Manual And Warranty Information page 3

Illuminated Beauty Mirror Features
• Incandescent Light – Soft glare-free & shadow-free viewing
• 5x/1x Magnification – Two-sided mirror with normal and 5x
magnification
• 6" Diameter
• Illuminate with adaptor or 3 "AA" batteries (not included)
• Stable, non-slip base
• Fog Free
• Mirror Measures 6.75"L x 4.25"W x 12"H
• Satin Nickel Finish
• Includes two replacement bulbs
Instructions for Use
This mirror operates with 3 "AA" batteries (not included) or an
adaptor (included).
To Install Batteries:
• Remove Battery Cover (Fig. 2)
• Insert 3 "AA" batteries following the "+" and "-" signs. DO
NOT MIX OLD AND NEW BATTERIES; DO NOT MIX ALKA-
LINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE
(NICKEL-CADMIUM) BATTERIES.
• Snap battery cover back into place.
To Use with Adaptor:
• Insert the adaptor into the back of the base.
• Plug the adaptor into a 120-volt outlet.
• Place mirror on an even surface.
• Adjust the mirror to either normal or magnified viewing. To do
this swivel the mirror to the viewing side of your preference
while firmly holding down the base.
• Push On/Off switch upward to turn unit on. (Fig. 1)
• When finished push On/Off switch down to turn off and unplug
the adaptor from the outlet.
4
To Replace Bulb
Caution: Before replacing the bulb, always turn mirror off
and allow it to cool for at least 5 minutes.
• Remove the two screws on the side of the mirror (Fig. 1)
with a Phillips screwdriver.
• Take off the mirror casing by gently pulling apart at the
seam (Fig. 1).
• Unscrew light bulbs and replace with new ones. For your
convenience, two replacement bulbs are included.
• Replace the mirror casing and line up the screw holes.
• Screw back into place.
Unscrew to
replace bulbs
Mirror
Casing
Unscrew
to replace
bulbs
On/Off
Switch
Figure 1
5
Line up
battery signs
Battery
Cover
-
+
+
-
- +
Figure 2