Cleaning The Appliance - HoMedics spa REFLECTIVES M-6011 Instruction Manual And Warranty Information

Table of Contents

Advertisement

Available languages

Available languages

To Use the Spinning Facial Cleanser Attachments:
1. Select the desired attachment to begin your facial.
• Cleansing Brush – Use with your favorite soap to gently cleanse
and exfoliate face and neck
• Sponge – Use with soap and water to clean face or apply moisturizer (Extra
Sponges are provided. Simply remove old sponge and and replace with new
sponge when needed.)
• Massage Rollers – Tone and relax facial and neck muscles
2. Snap on attachment (Fig. 2).
3. Select your desired speed – Press the on/off button once for LO and twice
for HI. Corresponding LEDs will light to indicate LO or HI.
4. When finished, turn the unit off, remove and rinse the attachment.
5. Place facial unit back into the charging base.
To Use Mist Feature:
1. Pull back tab on the mist chamber (Fig. 3)
2. Place chamber under a narrow stream of running water.
NOTE: Do not allow unit to be heavily immersed or submerged in water.
3. Close tab.
4. Press the mist button (Fig. 1) to dispense a cool gentle mist.
Steps for a Complete Facial:
1. Use cleansing brush attachment with your favorite cleanser in
circular motions on your face to gently exfoliate.
2. Use large and small suction cup attachments to deep cleanse your
pores and remove impurities from below the skin's surface.
3. Press the mist button to spray a gently mist across your face to
close your pores once cleaning is complete.
4. Apply moisturizer with sponge attachment for thorough coverage and to improve `
your skin's texture.
5. Tone your face and neck with the relaxing massage roller attachment.

Cleaning the Appliance:

1. Remove the attachment from the facial unit
2. To clean use a damp cloth to wipe down the facial unit. DO NOT
RINSE APPLIANCE UNDER WATER. Unit is NOT waterproof.
3. Attachments should be removed and then rinsed under warm water
until clean. DO NOT place appliance under running water – only attachments.
6
4. Use small cleaning brush provided to clean out the attachment socket,
mist chamber and the mist sprayer.
5. Allow facial unit and attachments to dry before storing.
Storing:
Store facial unit in the charging base. Place the five attachments and cleaning
brush back into its storage case. NOTE: Never use benzene, thinners, or any
other organic solvents to clean the product. Use of these cleansers will damage
the unit.
Figure 1
Cleansing
Brush
Sponge
On/Off
Massage
Rollers
Large
Charging
Suction Cup
Base
Small
Suction Cup
Figure 2
Mist Sprayer
Mist Button
Facial Unit
Figure 3
Mist
Chamber
7

Advertisement

Table of Contents
loading

Table of Contents