Related Manuals for Reaim BY02-VBW-WT
Summary of Contents for Reaim BY02-VBW-WT
- Page 1 High-Pressure Washer BY02- VBW-WT Do not use this device before reading the instructions. CAUTION :...
-
Page 2: Safety Instructions
must not be directed towards 1. Safety Instructions persons, electrical equipment appliance been connected to the mains or designed solely for private the appliance itself. use outdoors and not for commercial use. Keep this appliance away from heat, direct sunlight, moisture and rain, ice and sharp edges. - Page 3 supplied or recommended by Never use the machine in an manufacturer. Using environment where there is a other cleaning products or danger of explosion. chemical products It is forbidden to clean affect the safety of the surfaces containing asbestos appliance.
- Page 4 devices, high pressure hoses If the power cable and handgun. damaged, must replaced WARNING: If you have an manufacturer, their service extension cable, it must be agent qualified waterproof. professional in order to WARNING: When avoid any danger. switch on the machine, a ...
- Page 5 high pressure washer to the WARNING: power supply: Always connect the system separator to the water supply Connecting the electrical and never directly to the connection should be done device! by a qualified electrician conforming to 60364-1 CEI It is recommended that the electrical supply to this machine should comprise a residual...
-
Page 6: Table Of Contents
Thank you for choosing the BY02-VBW-WT High-Pressure Washer The Circuitry Contents Chapter Page 1. Safety Instructions 2. Getting Started 3. Operating your pressure washer 4. End of operation instructions 5. Environmental protection 6. Maintenance, cleaning and repairing. 7. Breakdown service... -
Page 7: Getting Started
3. Operation instructions 2. First time instructions This section will explain in details how to 3.1 Connection of garden hose make high pressure washer ready for use. Screw the water inlet coupling (13) tight on SAFETY DEVICES to the water inlet Note: The inlet filter (A) ... - Page 8 water, max. pressure: 10 bar, max. temperature: 60°C). Push the lance into the trigger gun Turn on the water. When inserted turn it. Caution: Make sure the lance is properly fixed to the gun 3.5 Start/stop of the machine Attach the nozzles. Caution: When attaching the nozzle the button (A) on the The trigger gun (2) and lance is affected by nozzle should come out again.
-
Page 9: End Of Operation Instructions
3.6 Multi Nozzle The pressure can for the multi nozzle be adjusted by tuning it. WARNING: Do not do this under operation to avoid that the hand hits the jet. 3.8 Parking holder The trigger gun and lance can be stored 3.7 Foam Sprayer during and after operation in the parking Unscrew the container (A) from the foam... -
Page 10: Environmental Protection
Restart the machine and activate the trigger Clean the connectors of dust and sand. of the trigger gun Let the machine run until Rinse the detergent spraying attachment no more water runs through the trigger gun after use. Stop the machine, unplug and wind up hose Clean the nozzles. -
Page 11: Breakdown Service
7. Breakdown service Symptom Cause Recommended action The machine will not The machine is not plugged-in Plug the machine in start Faulty receptacle Try another receptacle The fuse has blown Replace the fuse Unplug other appliances Faulty extension cable Try without the extension cable Fluctuating pressure The pump is drawing in air Check that hoses and connections are airtight. - Page 12 WEEE - Waste of Electric and Electronic Equipment English Português The symbol on the product or on its packing Símbolo no produto ou na embalagem indica que indicates that this product may not be treated as esse produto não deve ser tratado como um household waste.
- Page 13 WEEE - Waste of Electric and Electronic Equipment Español Suomi El símbolo que aparece en el producto o en su Tuotteessa pakkauksessa oleva symboli embalaje indica que este producto no puede ser ilmaisee, että tuotetta hävittää tratado como residuo doméstico. En su lugar, debe talousjätteen mukana.
Need help?
Do you have a question about the BY02-VBW-WT and is the answer not in the manual?
Questions and answers
How do I attach the spray bottle to the hose line ??
To attach the spray bottle to the hose line for the Reaim BY02-VBW-WT:
1. Unscrew the container (A) from the foam sprayer.
2. Add detergent to the container (A).
3. Screw the container back onto the foam sprayer.
4. Press button (C) on the quick connector.
5. Insert the foam sprayer into the gun until it clicks into place.
6. Adjust the amount of detergent with button (B) as needed.
Caution: Ensure button (C) is properly engaged when attaching the soap bottle.
This answer is automatically generated