Comtrend Corporation VR-303 User Manual page 80

Field
Traffic Class Name
Rule Order
Rule Status
Classification Criteria
Class Interface
Ether Type
Source MAC Address
Source MAC Mask
Destination MAC
Address
Destination MAC Mask
Classification Results
Specify Class Queue
Specify Class Policer
Mark Differentiated
Service Code Point
Mark 802.1p Priority
Set Rate Limit
Description
Enter a name for the traffic class.
Last is the only option.
Disable or enable the rule.
Select an interface (i.e. Local, eth0-4, wl0)
Set the Ethernet type (e.g. IP, ARP, IPv6).
A packet belongs to SET-1, if a binary-AND of its source
MAC address with the Source MAC Mask is equal to the
binary-AND of the Source MAC Mask and this field.
This is the mask used to decide how many bits are checked
in Source MAC Address.
A packet belongs to SET-1 then the result that the
Destination MAC Address of its header binary-AND to the
Destination MAC Mask must equal to the result that this
field binary-AND to the Destination MAC Mask.
This is the mask used to decide how many bits are checked
in Destination MAC Address.
Packets classified into a queue that exit through an
interface for which the queue is not specified to exist, will
instead egress to the default queue on the interface.
Packets classified into a policer will be marked based on
the conforming action of the policer
The selected Code Point gives the corresponding priority to
packets that satisfy the rule.
Select between 0-7. Lower values have higher priority.
The data transmission rate limit in kbps.
79