Water Supply Connection - Frigidaire FRTD2021AS Use & Care Manual

14

WATER SUPPLY CONNECTION

Ice Maker Models Only

NOTE
Automatic ice makers are optional acces-
sories that you may install in most models
at any time. Visit Frigidaire.com for infor-
mation about Ice Maker Kit IMKTF20A.
WARNING
To avoid electric shock, which can cause
death or severe personal injury, dis-
connect the refrigerator from electrical
power before connecting a water supply
line to the refrigerator.
CAUTION
To Avoid Property Damage:
• Use stainless steel braided tubing
for the water supply line. Do not
use water supply tubing made of
¼" plastic. Plastic tubing greatly
increases the potential for water
leaks, and the manufacturer will not
be responsible for any damage if you
use plastic tubing for the supply line.
• DO NOT install water supply tubing
in areas where temperatures fall
below freezing.
• Chemicals from a malfunctioning
softener can damage the ice maker.
If the ice maker is connected to
soft water, ensure the softener is
maintained and working properly.
IMPORTANT
Ensure your water supply line connections
comply with all local plumbing codes.
Before Installing The Water Supply Line,
You Will Need:
• Basic Tools: adjustable wrench, flat-blade
screwdriver, and Phillips screwdriver
• Access to a household cold water
line with water pressure between 30
and 100 psi.
• A water supply line made of stainless
steel tubing. To determine the length
of tubing needed, measure the dis-
tance from the ice maker inlet valve
at the back of the refrigerator to your
cold water pipe, so the refrigerator
can be moved out for cleaning.
• A shutoff valve to connect the water
supply line to your household water
system. DO NOT use a self-piercing
type shutoff valve.
• Do not reuse compression fitting or
use thread seal tape.

NOTE
Check with your local building
authority for recommendations on
water lines and associated materials
prior to installing your new refrigerator.
Depending on your local/state building
codes, Frigidaire recommends for
homes with existing valves its Smart
Choice
water line kit 5304437642
®
(with a 6' Stainless Steel Water Line)
and for homes without an existing
valve, Frigidaire recommends its
Smart Choice water line kit
®
5304493869 (with a 6' Polyline
Waterline). Please refer to
Frigidaire.com for more information.
To Connect the Water Supply Line To the
Ice Maker Inlet Valve
1. Disconnect the refrigerator from the
electrical power source.
2. Place the end of the water supply
line into a sink or bucket. Turn ON
the water supply and flush the supply
line until the water is clear. Turn OFF
the water supply at the shutoff valve.
3. Remove the plastic cap from the wa-
ter valve inlet and discard the cap.