Connecting - Verizon Wireless PX-700 Manual

USING VZACCESS MANAGER
NOTICE: Note that with certain Wi-Fi adapters the signal
@
strength for Wi-Fi networks is not accurate until you connect
to the network.
NOTE: The NationalAccess connection is only created when
@
the WWAN option is selected during setup and if you are
using a NationalAccess capable device that does not support
the Verizon Wireless BroadbandAccess service. If you are
using a BroadbandAccess capable device a BroadbandAccess
connection will be created. This connection will use
BroadbandAccess if available and will automatically attempt
a NationalAccess connection when BroadbandAccess is not
available.
NOTICE: If you change wireless devices, you will need to
@
run the Setup Wizard again. To do this make sure that your
wireless device and cable are connected, then select "Run
Wizard" from the "Options" menu.

■ CONNECTING

Once your Wi-Fi or WWAN device is properly configured,
connecting to the Internet is as simple as selecting the
network connection type shown in the list and clicking
the Networks button. Note that the Networks button
immediately above the list will change to "Connect" or
"Connect Wi-Fi" based on the current selection in the
networks list.
1 If you are outside the US, Canada or Puerto Rico
and using the USB device, select the "VZGlobal"
connection. If in the US and using the device for
the domestic network, select one of the following
connections: "NationalAccess – BroadbandAccess" or
"NationalAccess."
16
CONNECTING