Troubleshooting - Progress PHN23001X User Manual

Table of Contents

Advertisement

20 Progress
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
Replacing the lamp
WARNING! Risk of electric
shock.
The lamp can be hot.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The cooking zones do not
operate.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
A
Possible cause
Refer to the operating instructions for the built-in cooking sur‐
face.
The oven is deactivated.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.

Advertisement

Table of Contents
loading

Table of Contents