Table of Contents
Advertisement
a. Install the saddle to the port side of the rack rails using four 10-32 screws with square-cone
washers, two screws on each side of the saddle. Tighten the screws to 32 in-lb (36.86 cm-kg).
b. Move the mid-mount brackets into position so they align with the rack mounting holes on the
nonport side of the rack. Secure the mid-mount brackets to the rack with four 10-32 screws with
square-cone washers, two on each side. Tighten the screws to 32 in-lb (36.86 cm-kg).
c. Tighten the two 10-32 adjusting screws on each mid-mount bracket.
Figure 17. Saddle installed in a rack
1 - Saddle
2 - 10-32 screws with square-cone washers
3 - Adjusting screws (two on each side of the saddle)
Note: For rails with round holes, use the clip nuts (refer to Figure 16 on page 34) on the rack rails
for securing 10-32 screws. For rails with square holes, use the retainer nuts (refer to Figure 16 on
page 34). Also refer the following figure.
35
Mounting the Device
Advertisement
Table of Contents
