ReadyNet AC1100MSF Manual
Hide thumbs Also See for AC1100MSF:

Advertisement

Quick Links

Home
PBXware
SERVERware
TELCOware
SIPmon
SIPProt
Desktop & Mobile
BRM
UADs
Appliances
EOL
From Bicom Systems Wiki
Contents
1 Introduction - How to use ReadyNet AC1100MSF with PBXware
Introduction - How to use ReadyNet
AC1100MSF with PBXware

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AC1100MSF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ReadyNet AC1100MSF

  • Page 1: Table Of Contents

    SIPmon SIPProt Desktop & Mobile UADs Appliances From Bicom Systems Wiki Contents 1 Introduction - How to use ReadyNet AC1100MSF with PBXware 1.1 Requirements 2 Installation 2.1 Power Adapter 2.2 IP Address 2.3 Factory Settings 3 Registering Device 3.1 Manual Configuration 3.2 Auto Provisioning...
  • Page 2: Requirements

    This "How to" is written as a general guide on how to use your ReadyNet AC1100MSF with PBXware. It covers the most common tasks required in order to have your ReadyNet AC1100MSF working efficiently. Requirements 1. Identify ReadyNet device To start and successfully complete registration of your ReadyNet device you need to know which device model you will setup.
  • Page 3: Installation

    This step is not required for out-of-the-box devices, however, if the device has been already used then it is a must. For ReadyNet AC1100MSF press the reset button at the back of your router device for 10 seconds, this will wipe out any changes made to your router.
  • Page 4: Manual Configuration

    2. UAD settings Navigate to Settings:UAD. Make sure ReadyNet AC1100MSF UAD is enabled. To check the UAD status click on the edit icon corresponding to your ReadyNet AC1100MSF UAD phone. Make sure Status is set to Active, Auto provisioning is set to No, and DHCP is set to Yes.
  • Page 5 STRONGLY recommended not to change the system generated value to a simple value like "1234" or "1003" etc. An auto-generated PIN will allow access to voicemail and online self-care. Registering Phone This chapter describes how to register ReadyNet AC1100MSF device using Hostname or IP Address.
  • Page 6: Auto Provisioning

    Hostname or IP Address 1. Login to device web administration interface Open a new browser window and enter your phone IP address in order to access the device web administration interface login screen. Example: http://192.168.1.22. Login to device web administration interface with your username and password. Please note, factory default login details are username: admin and password: pz938q11msf.
  • Page 7 2. UAD settings Navigate to Settings:UAD. Make sure ReadyNet AC1100MSF UAD is enabled. To check the UAD status click on the edit icon corresponding to your ReadyNet AC1100MSF phone. Make sure Status is set to Active, Auto provisioning is set to Yes, and DHCP is set to Yes.
  • Page 8 Click on the Save button. Creating Extension Registering Phone This chapter describes how to register ReadyNet AC1100MSF device using DHCP or TFTP. The following topics are covered: - DHCP - TFTP DHCP 1.
  • Page 9 If there is no DHCP in your network, you can still auto provision your ReadyNet AC1100MSF device. Please refer to your ReadyNet AC1100MSF phone device User Guide for instruction about setting static IP address. After you configure your ReadyNet device to use a static IP address, continue with the following steps.

Table of Contents