Table of Contents
Advertisement
Maintenance
Recovery and Storage
Once, the Resilient is recovered, its function is complete but it is important that it be stored and
maintained properly for future deployments.
As soon as possible after the Resilient is recovered, all batteries should be removed and
discarded. The Resilient should be cleaned and inspected for corrosion or water ingress. O-rings
should be visually inspected. Any concerns should be discussed with Xeos Support (1-902-444-
7650 or support@xeostech.com) prior to storage.
The Resilient should be stored as follows:
Dry location
Assembled, without batteries but with O-rings in place
Ambient temperature of -40° C to +85° C
Either horizontal or vertical storage is permitted
Battery Compartment
Source:
O-Rings
Part Number:
Source:
Maintenance:
Resilient User Manual Version 2.0
Repair or replacement must be done by Xeos Technologies Inc. 1-902-
444-7650 or
support@xeostech.com
Only use new, approved batteries for deployments. In the event used
batteries are for short term testing, batteries must have equivalent
battery voltages to prevent reverse charge forming and subsequent
battery leakage.
Visual inspection of the battery compartment should be done after
each deployment to ensure there has been no leakage. Signs of
corrosion, leakage or water ingress should be reported to Xeos
immediately.
568-138 90D DURO BUNA (Top, White Section)
568-137 90D DURO BUNA (Bottom, Black Section)
O-rings may be purchased through Xeos Technologies Inc. or from a
variety of vendors. Please call for assistance if required.
O-rings should be visually inspected prior to each deployment, no
matter how short. Any evidence of wear or stretching requires that
they be replaced.
29
Advertisement
Table of Contents
