Table of Contents
Advertisement
Power connector cable
NOTE:
The power connector cable is available in the Cable Kit, spare part number 501891-001.
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Memory module (see
c.
WWAN module (see
d.
WLAN module (see
e.
Keyboard (see
f.
Top cover (see
g.
Fan (see
h.
System board (see
Remove the power connector cable:
1.
Remove the power connector (1) from the clip built into the base enclosure.
74
Chapter 4 Removal and replacement procedures
Battery on page
Hard drive on page
Memory module on page
WWAN module on page
WLAN module on page
Keyboard on page
Top cover on page
Fan on page
55)
System board on page
39).
40).
43)
45)
47)
50).
53)
59)
Advertisement
Table of Contents
