DeVilbiss FAC28-1 Owner's Manual
DeVilbiss FAC28-1 Owner's Manual

DeVilbiss FAC28-1 Owner's Manual

Permanently lubricated air compressor

Advertisement

Quick Links

DeVILBISS AIR POWER COMPANY
OWNERS MANUAL FOR
PERMANENTLY LUBRICATED AIR COMPRESSOR
Model No.
Horsepower
SCFM @ 40 psig
SCFM @ 90 psig
Cut-In
Cut-Out
Bore
Stroke
Voltage/Hertz/ Phase
Minimum Branch Circuit Requirement
*Fuse Type
Amperage at Max. Load
Tank Size
*A circuit breaker is preferred. Use only a fuse or circuit breaker that is the same rating as
the branch circuit the air compressor is operated on. If the air compressor is connected to
a circuit protected by fuses, use quick acting fuses.
SAFETY GUIDELINES - DEFINITIONS
This manual contains information
that is important for you to know
and understand. This information
relates to protecting YOUR SAFETY
and PREVENTING EQUIPMENT
PROBLEMS. To help you recog-
nize this information, we use sym-
bols to the right. Please read the
manual and pay attention to these
sections.
MGP-FAC28-1
4/6/98
(For Home Use Only)
MODEL NO.
FAC28-1
SPECIFICATION CHART
URGENT SAFETY INFORMATION - A HAZARD
THAT WILL CAUSE SERIOUS INJURY OR LOSS
OF LIFE.
IMPORTANT SAFETY INFORMATION - A
HAZARD THAT MIGHT CAUSE SERIOUS
INJURY OR LOSS OF LIFE.
DeVilbiss Air Power Company • 213 Industrial Dr. • Jackson, TN 38301-9615
FAC28-1
2
3.7
2.6
100 PSI
125 PSI
1 7/8"
1 1/4"
120/60/1
15 AMPS
Quick Acting
10 AMPS
8 Gallon
Information for preventing damage to
equipment.
Information that you should pay special
attention to.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FAC28-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for DeVilbiss FAC28-1

  • Page 1 IMPORTANT SAFETY INFORMATION - A manual and pay attention to these Information that you should pay special HAZARD THAT MIGHT CAUSE SERIOUS attention to. sections. INJURY OR LOSS OF LIFE. DeVilbiss Air Power Company • 213 Industrial Dr. • Jackson, TN 38301-9615 MGP-FAC28-1 4/6/98...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Page Page ON-RECEIPT INSPECTION....2 Extension Cords ....... 7 Voltage and Circuit Protection ..7 WARRANTY .......... 3 Grounding Instructions ..... 8 Additional Regulators and SAFETY GUIDELINES 4 Controls ..........8 Break-In Procedures ......8 WARNING CHART ......4-5 OPERATING PROCEDURES ....
  • Page 3: Warranty

    (income producing) are covered by a 90 day warranty. DeVilbiss Air Power will repair or replace, at DeVilbiss's option, products or components which have failed within the warranty period. Repair or replacement, and service calls on 60 and 80 gallon air compressors, will be handled by Authorized Warranty Service Centers and will be scheduled and serviced according to the normal work flow and business hours at the service center location, and depending on the availability of replacement parts.
  • Page 4: Safety Guidelines

    IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS • IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. HAZARD HOW TO PREVENT IT WHAT CAN HAPPEN AIR TANK RISK OF BURSTING...
  • Page 5 HAZARD WHAT CAN HAPPEN HOW TO PREVENT IT RISK OF ELECTRICAL WIRING REPAIRS REPAIRS ATTEMPTED UNQUALIFIED ELECTRICAL SHOCK REQUIRE ON THIS PRODUCT SHOULD BE PERSONNEL RESULT SERIOUS PERFORMED AUTHORIZED SERVICE INJURY OR DEATH BY ELECTROCUTION. CENTER PERSONNEL ACCORDANCE WITH NATIONAL AND LOCAL ELECTRICAL CODES.
  • Page 6: Glossary

    DUTY CYCLE All DeVilbiss Air Power manufactured air compressors should be operated on not more than a 50% duty cycle. This means an air compressor that pumps air more than 50% of one hour is considered misuse, because the air compressor is undersized for the required air demand.
  • Page 7: Description Of Operation

    DESCRIPTION OF OPERATION than that desired, then bring it up to the desired pressure. Air Compressor Pump: To compress air, the piston Depending on the air requirements of each particular moves up and down in the cylinder. On the downstroke, accessory, the outlet regulated air pressure may have to air is drawn in through the intake valves.
  • Page 8: Grounding Instructions

    INSTALLATION AND BREAK-IN PROCEDURES GROUNDING INSTRUCTIONS Additional Regulators and Controls Since the air tank pressure is usually greater than that RISK OF ELECTRICAL SHOCK! IN THE EVENT which is needed, a regulator is employed to control the air OF A SHORT CIRCUIT, GROUNDING REDUC- pressure ahead of any individual air driven device.
  • Page 9: Operating Procedures

    OPERATING PROCEDURES When you are finished: 1. Before attaching air hose or accessories, make sure 6. Set the “OFF/AUTO” lever to “OFF”. the OFF/AUTO lever is set to “OFF” and the air regulator or shut-off valve is closed. 7. Turn the regulator counterclockwise and set the outlet pressure to zero.
  • Page 10: Troubleshooting Guide

    TROUBLESHOOTING GUIDE PERFORMING REPAIRS MAY EXPOSE VOLTAGE SOURCES, MOVING PARTS OR COM- PRESSED AIR SOURCES. PERSONAL INJURY MAY OCCUR. PRIOR TO ATTEMPTING ANY REPAIRS, UNPLUG THE COMPRESSOR AND BLEED OFF TANK AIR PRESSURE. PROBLEM CAUSE CORRECTION Pressure switch does not shut off Move the pressure switch lever to the “OFF”...
  • Page 11 TROUBLESHOOTING GUIDE (Continued) CORRECTION PROBLEM CAUSE Compressor is not supplying Check valve restricted. Remove and clean, or replace. enough air to operate acces- Air leaks. Tighten fittings. (See Air Leaks Section of Trou- sories. (cont'd) bleshooting Guide.) Motor will not run. Motor will start automatically when tank pressure Tank pressure exceeds pressure drops below “cut-in”...
  • Page 12 AIR COMPRESSOR DIAGRAM & PARTS LIST DESCRIPTION PART NUMBER Safety Valve 97503734 Drain Valve SS-2707 Wheel 6" (2 used) CAC-4299 Shoulder Bolt (2 used) CAC-60 Nut Hex 3/8-16 UNC-2B (2 used) SSF-8080-ZN Handle AC-0345 Screw #10 - 16 x 1 Type AB (2 used) SSF-612 Molded Foot Bumper (2 used) AC-0364...
  • Page 13: Pump Diagram

    PUMP DIAGRAM 13 — ENG...
  • Page 14: Parts List

    PARTS LIST PART NUMBER DESCRIPTION Screw #10-24 x 7/8 LG. hex head thd forming (4 used) ----- Cylinder head CAC-1196 CAC-1212 Tube seal CAC-1199 Head gasket CAC-4323 Valve plate assembly SSG-8169 "O" ring Outlet Tube DAC-269 • Rod assembly ----- ----- Screw 3/8-16 x 1.25 LG.
  • Page 15: Service Notes

    SERVICE NOTES 15 — ENG...
  • Page 16 •Model number of your product •Part number and description of the item you wish to purchase Attach Sales Receipt Here. Retain Original Sales Receipt as Proof of Purchase for Warranty Repair Work. DeVilbiss Air Power Company • 213 Industrial Drive • Jackson, TN 38301-9615...

Table of Contents