Electrolux KESC8300L User Manual page 24

24 www.electrolux.com
Problem and alarm code
The level of water inside
the appliance is too high.
The display shows iF1.
The appliance stops and
starts more times during
operation.
The programme lasts too
long.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
The remaining time in the
display increases and
skips nearly to the end of
the programme duration.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
The appliance door opens
during the wash cycle.
Rattling or knocking
sounds from the inside of
the appliance.
The appliance trips the cir‐
cuit-beaker.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
Possible cause and solution
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation in‐
structions.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delay start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• Activating options increases the programme dura‐
tion.
• Refer to the consumption values table in the chapter
"Programme selection".
• This is not a defect. The appliance is working cor‐
rectly.
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the bas‐
kets.
• The AirDry function is activated. You can deactivate
the function. Refer to "Basic settings".
• The tableware is not properly arranged in the bas‐
kets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneous‐
ly all the appliances in use. Check the socket amper‐
age and the capacity of the meter or turn off one of
the appliances in use.
• Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.