To Install The Surround Or Centre Speaker On The Wall - Sharp HT-X15H Operation Manual

To install the surround or centre speaker on the wall

HT-X15H
ENGLISH
Sharp has designed the surround or centre speaker so you can
hang it on the wall.
Example: Surround speaker
1
Make a hole in the wall using
a drill.
2
Drive a wall mount plug into
the hole using a hammer,
until it is flush with the wall
surface.
3
Drive four screws into the wall for each speaker, as shown
in the illustration.
Make sure that both the screw and the wall can support a load
of 3.0 kg.
Surround speaker mounting screw
Wall surface
4
Attach the supplied pattern paper to the wall, and fix 2 sur-
round speaker wall brackets with the supplied 4 screws.
Surround speaker
wall bracket
Wall surface
E-67
5
Remove the pattern paper and tighten the screws. Hang
the surround speaker on the brackets.
28 mm (1-1/8")
Wall surface
6 mm (1/4")
Note:
You can mount the centre speaker in the same way.
CAUTION:
Make sure to prevent the surround speaker (1.4 kg) or centre
speaker (1.4 kg) from falling when mounting on the wall.
Before mounting, check the wall strength. (Avoid the veneer plas-
ter or whitewashed wall. The surround or centre speaker may
fall.) If it is not clear, consult with a qualified service technician.
Check all mounting screws for looseness and that they are
engaged in the surround or centre speaker.
Mount the surround or centre speaker on the wall with 4 screws.
Select a good location. If not, accidents may occur or the sur-
round or centre speaker may get damaged.
Avoid placing on a bed, sofa, water tank, sink and hallway wall.
SHARP is not responsible for accidents resulting from improper
installation.
Pattern paper
for surround speaker
Surround speaker
mounting screw
05/6/7 HT-X15H(H)E7.fm TINSZA064SJZZ