To Mount The Sound Bar Speaker On The Wall - Sharp AQUOS BD-MPC41U Operation Manual

Positioning the Speaker System

To mount the Sound Bar Speaker on the wall

Wall mount angle fixed on the wall
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal
position as below.
509 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw
point marks on the pattern paper by using a drill.
1-9/16" (40 mm)
3/8" (8-9 mm)
Wall surface
3
Fix a wall mount plug into the hole using a
hammer until it is flush with the wall surface.
1-9/16" (40 mm)
3/8" (8-9 mm)
Wall surface
4
Screw the wall mount angle to the wall as shown
in the illustration. (Total screw is 8 pieces)
Wall mount angle
Wall surface
Wall mount angle
Wall surface
Wall surface
NOTE
• Make sure all screws are fully tighten. (screws are not
supplied)
20
44 mm
29 mm
Pattern paper
(screws x 4)
(screws x 4)
Wall mount angle
Installing the Sound Bar Speaker
Before installing the speaker, connect the speaker
connection cords to the speaker. (See pages 22-23.)
1
Align the wall mount slot at the speaker to the
wall mount angle.
2
Slot the speaker into the wall mount angle.
3
Fix them securely.
Wall surface