Replacing The Batteries; Cleaning And Maintenance - Fanelite R1-T User Manual, Installing And Operating Manual

Table of Contents

Advertisement

Available languages

Available languages

Press the speed button to adjust the speed. The indicator corresponding to the selected
speed lights up.
L - Low speed
M - Medium speed
H - High speed
Mode
Press the mode button to change the wind mode, the indicator corresponding to the selected
mode lights up.
Normal mode : the fan operates normally according to the selected speed.
Natural mode : the fan reproduces the effect of the wind by operating alternately at different
speeds and intermittences : low, medium and strong effects of natural wind.
Sleep mode : When you fall asleep, the body temperature decreases gently. This means that
you are less and less in need of the fan as time goes by while you sleep. If you select this
mode, the fan will reduce its speed and reproduce the effect of the natural wind in different
ways depending on the selected speed. The night mode is ideal in case of sensitivity to
colds.
Timer
You can set the timer by pressing the timer button so that the fan turns off automatically after
the selected time has been reached. Press the timer button to set the timer, up to 9 hours.
Each time the button is pressed the timer increases by one hour and the selected time is
displayed on the indicator. To deactivate the timer press the button until 0h appears on the
indicator.
Oscillation
To activate the oscillation, press the oscillation knob on the motor block. To deactivate the
oscillation, raise the oscillation knob.
Pitch angle
You can adjust the angle of the head manually by moving the fan head vertically. Simply
raise or lower the fan head manually to the desired position. It is normal to hear clicks.
WARNING : Only do so when the fan is off and the plug is disconnected from the
mains. Never force to avoid damaging the appliance.
Notes
The fan is equipped with a room temperature sensor. The temperature in °C is constantly
displayed when the fan is ON.
All indicators turn off automatically after 30 seconds. To turn them back on, press any button
on the control panel or remote control, they will turn off again after 30 seconds.

6. REPLACING THE BATTERIES

WARNING : Before replacing the batteries, carefully read the safety instructions in this
manual.
Slide down the battery compartment cover (on the back of the remote control) to open it.
Remove and insert two identical batteries (1.5V AAA) with correct polarity. Close the cover
by sliding it up.

7. CLEANING AND MAINTENANCE

16

Advertisement

Table of Contents
loading

Table of Contents