Replacing The Batteries - Fanelite X01A-DC User Manual

Oscillation
To activate the oscillation, press the SWING button. To deactivate the oscillation, press
again the SWING button.
Wind modes
Press the MODE button to change the wind mode : normal or natural.
- Normal mode : the fan operates normally according to the selected speed.
- Natural mode : the fan reproduces the effect of the wind by operating alternately at
different speeds and intermittences : low, medium and strong effects of natural wind.
The corresponding LED on the control panel will light up, indicating that natural mode is
activated.
Notes
If you are not going to use your fan for a long time, we advise you to disconnect the
appliance from the AC power.
The remote control has the same functions than the control panel of the fan and must be
directed to the fan's display to operate.
There is a special storage for the remote control at the back of the fan (see below).

6. REPLACING THE BATTERIES

WARNING : Before replacing the batteries, carefully read the safety instructions in this
manual.
When the batteries are empty, please replace them by following the procedure below :
1. Slide down the battery compartment cover (on the back of the remote control) to open it.
2. Remove and insert two identical batteries AAA with correct polarity.
3. Close the cover by sliding it up.
17