ABB 10DX3111G Instruction Manual page 5

SAFETY SUMMARY
GENERAL
WARNINGS
SPECIFIC
WARNINGS
SPECIFIC
CAUTIONS
10DX3111G INSTRUCTION MANUAL
POSSIBLE PROCESS UPSETS. Maintenance must be performed
only by qualified personnel and only after securing equipment
controlled by this product. Adjusting or removing this product
while it is in the system may upset the process being controlled.
Some process upsets may cause injury or damage.
RETURN OF EQUIPMENT. All equipment being returned to ABB
Instrumentation for repair must be free of any hazardous materials
(acids, alkalis, solvents, etc.). A Material Safety Data Sheet (MSDS)
for all process liquids must accompany returned equipment. Con-
tact ABB Instrumentation for authorization prior to returning
equipment.
INSTRUCTION MANUALS. Do not install, maintain or operate this
equipment without reading, understanding and following the
proper ABB Instrumentation instructions and manuals, otherwise
injury or damage may result.
ELECTRICAL SHOCK HAZARD. Equipment powered by AC line
voltage presents a potential electric shock hazard to the user.
Make certain that the system power is disconnected from the oper-
ating branch circuit before attempting electrical interconnections
or service.
Equipment powered by an AC line voltage presents a potential
electric shock hazard to the user. Make certain that the system
power input leads are disconnected from the operating branch
circuit before attempting electrical interconnections or service.
(pg. 4-2)
Do not inspect electrodes unless pipe is de-pressurized and
drained. (pg. 4-3)
Do not attempt electrode inpection or replacement with a filled or
pressurized pipeline. Personal injury may result from such prac-
tice. (pg. 4-4)
Never allow support for the Magnetic Flowmeter to bear upon the
inner surface of the meter pipe section inasmuch as the liner may
become damaged. Do not lift the meter by the electrode bosses.
(pg. 2-2)
Excercise extreme care when withdrawing electrode from its seat
so that little or no tension is exerted on the connecting electode
wire. If this wire should break within the meter pipe, the meter is
not repairable. (pg. 4-6)
I