ABB 10DX3111G Instruction Manual page 30

Magnetic flowmeter sizes 30" through 78"

Hide thumbs Also See for 10DX3111G:

Table of Contents

10DX3111 INSTRUCTION MANUAL

2.5.2 Interconnections

Meters designed for accidental and continuous submersion have cables for interconnection to the

Converter/Drive already attached to the primary. The wires are identified as shown in Figure 2-10.

Meters designed for accidental submergence must be wired between the conduit boxes and the

Converter/Driver by the user. The terminals in the conduit boxes are identified in Figure 2-11. A

specific electrical interconnection diagram and procedure which defines wiring to be installed be-

tween your ABB Instrumentation Magnetic Flowmeter and the Converter/Driver is provided in the

Converter/Driver instruction bulletin.

FIGURE 2-10. WIRE IDENTIFICATION FOR ACCIDENTAL

& CONTINUOUS SUBMERGENCE METERS

2-15

Table of Contents