Springfree SF90E Assembly, Installation, Care, Maintenance, And Use Instructions page 15

add 2 to each group
Figure 15-A: Adding 2 rods per group
Figure 15-B: All rods attached to the mat
slide up
Figure 16: Sliding the net up the rods
Springfree™ Trampoline Model SF90E Trampoline and Enclosure Assembly, Installation, Care, Maintenance and Use Instructions Version 6.4
Step 15: Attaching the remaining
rods to the mat
Now install two more rods to the left of each
group while circling the trampoline.
Continue to circle around the trampoline
installing two rods per group until all rods are
connected (Figure 15-B).
Step 16: Sliding the enclosure net up
the rods
Lift the enclosure net from the ground, up on
to the trampoline mat. (It may be a tight it over
the mat edge). Please ensure the net does not
snag on the frame bolts as this may tear the net.
Circling the trampoline from right to left,
slide the net bottom strip up the rods to the
top, just under the mat edge. (The long zipper
will now end just left of the joint between the
legs).
To avoid unnecessary wear on the net, please
ensure that the bottom net weave band covers
the edge of the mat.
15