JUKI LK-1900BN Series Instruction Manual page 23

❸
After the completion of input of a comment, the screen is returned to the previous screen by pressing RE-
❾ .
TURN key
(5) Setting the thread tension
(6) Completing the setting
 ❷
* When READY key
* When READY key
changed.
* The thread tension can be changed even when the SET READY  LED lights up. The thread tension is
stored in memory with the start switch.
* Check the pattern number before use. If you press READY key
played, error display E010 will be shown on the screen. At this time, re-set the pattern number.
When turning OFF the power without pressing READY key
No., X/Y scale, number of max. rotation, and thread tension are not memorized.
❻ ❼ ❾
❼
❻ ❾

❷ is pressed, the set values of pattern No., X/Y scale, etc. are memorized.
❷ is pressed, SET READY LED  goes out. Setting of each item can be
－
20
On the comment input screen, as many as 14 char-
acters can be input. The characters that can be input
are alphabets, numbers and symbols.
Press ITEM SELECT key
input position. Press DATA CHANGE key
to select the characters to be entered.
When you press RESET key
ter at the current input position is erased. When you
keep RESET key
ters which have been input are erased.
Press THREAD TENSION key
the C003 thread tension.
Press DATA CHANGE key
value you desire. (Input range: 0 - 200)
After setting the sewing data, press RETURN key
❾ to return to the input screen.
Press READY key
The work clamp moves. Then, SET READY LED 
lights up after the work clamp has gone up to enable
sewing.
When the presser is raised, be careful that
fingers are not caught in the presser since
the presser moves after having lowered.
❷ with pattern number 0 dis-
❷ , the set values of pattern
－
❻ to specify the
❸ , the charac-
❸ held pressed, all charac-
 to display
❼ to display the
❷ .
❼