imilab EC3 Outdoor User Manual page 7

3. Cover part of 2-in-1 power and LAN cable with the base plate as indicated.
4. Put the base plate on the wall. Ensure that the 2-in-1 power, and LAN cable goes
straight down. Secure the base plate by inserting the screws into the expansion nuts.
Note:
In order to prevent accidents and injuries, please secure the device firmly onto
•
the wall as illustrated. The wall on which the device is mounted must have a
loading capacity of at least 3 times the weight of the device.
Do not install the device near a heat source, such as an air-conditioner
•
compressor, air vent of a range hood or air vent of a gas water heater.
As the camera can be rotated horizontally, please pay attention to the safe
•
turning distance during installation. Do not install the device at a location where
its horizontal movement would be impeded.
7