modway EEI-3900 Manual

Office chair

EEI-3900 OFFICE CHAIR

Thank you for purchasing the MODWAY OFFICE CHAIR!

Before you start, here are some helpful advice:

1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3. Please do not use any tools other than those provided or recommended in these instructions.

4. Please do not throw away any of the packaging or the instruction until you have checked all the components

and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

and environmentally friendly way.

5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten

the components from time to time, so please save the tools that have been provided.

6. Please keep all the pieces out of reach of children.

1. Base

5. Seat

Customer Service 609-256-9000︱www.modway.com

2. Cylinder Column

6. Back

3. Castor

7. Armrest

Bolt M6x30mm

Bolt M6x22mm

Flat Washer

Allen Wrench

4. Chassis

Page 1 of 4

Table of Contents

Need help?

Do you have a question about the EEI-3900 and is the answer not in the manual?

Page 1 EEI-3900 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR! Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI-3900 OFFICE CHAIR STEP 1: 1. Please put Seat (5) upside down on a carpeted or padded surface. 2 pieces of Armrests (7) to the Seat (5) by using 6 pieces of Bolts (A) as shown and use Allen 2. Attach Wrench (D) to tighten all Bolts (A) clockwise as shown.
Page 3 EEI-3900 OFFICE CHAIR STEP 3. 1. Please put Base (1) on a carpeted or padded surface. 2. Insert 1 piece of Castor (3) into the Base (1) as shown by hand. 3. Repeat the same steps for the remaining 4 pieces of Castors (3).
Page 4 EEI-3900 OFFICE CHAIR STEP 5: Back Chassis (6) into the (4) as shown. Insert Attention: When you use the handle to adjust the height to be lower, please move away your feet from the base at the same time. Your office chair is ready to be used now! Customer Service 609-256-9000︱www.modway.com...