Advertisement
Adults and children must not come too close to the very hot surfaces of the radiant heater so
that they do not get burned and so that their clothing does not catch fire.
Children near the radiant heater must be carefully supervised.
Clothing or other flammable materials must not be hung on or near the heater.
Safety during repair and maintenance
The heater should only be repaired by a specialist.
Put a protective device that has been removed for maintenance purposes back on before re-
starting the heater.
Heater stand and location
The heater may only be used in outdoor areas and only in places where a
sufficient supply of fresh air can be guaranteed.
Make sure that there is sufficient space around the heater, i. e. 100 cm up-
wards and on all sides.
The heater must be set up on a level and firm surface.
Never operate the heater in potentially explosive environments, e. g. where
petrol or other highly flammable liquids or vapours are stored.
To prevent the heater from falling over in strong winds, its base must be
screwed to the ground.
Gas requirements
Only use propane or butane gas.
The assembly of pressure reducing valve and hose must correspond to the local regulations.
The installation must also comply with local requirements; if there are none, it must meet the
standard requirements for the storage and treatment of liquefied gases.
If the gas container is dented, rusted or damaged, it should be checked by seller of the gas
cylinder, as it can be dangerous in this condition. Never use a gas container with a damaged
valve connection.
The propane gas tank must be set up in such a way that the vapours generated by the gas
bottle can escape.
Never connect a propane gas tank to the heater without also using a pressure reducing valve.
Leak test
The gas connections attached to the heater are checked for leaks before shipping. However, a full
leak test must also be carried out at the installation site, as damage may have occurred during trans -
port due to improper handling or excessive pressure.
Make a soap solution from one part liquid soap and one part water. This soap solution can be
applied with a spray bottle, a brush, or a scrap of cloth. If there is a leak, bubbles will appear.
The heater must be checked for leaks when the gas bottle is full.
Make sure that the safety valve is in the OFF position.
Turn on the gas supply.
If a leak is found, the gas supply must be switched off again. Tighten any leaky connections,
turn on the gas supply and check the tightness again.
Never smoke during a leak test.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 63021
Page 5
04
2021-1
Advertisement
