Advertisement
Step 7:
1. Place the gas container housing on the post.
2. Connect the end thread of the inlet gas hose to
the pressure reducing valve.
3. Connect the pressure reducing valve to the gas
container and tighten with an adjustable wrench.
4. Place the liquid gas container on the stand.
5. Fasten the gas cylinder with the propane tank
strap.
Troubleshooting
Problem
Pilot flame does not ignite.
Pilot flame does not stay on.
Burner does not light.
If the device shows any errors during assembly or use, do not try to remodel it, but contact the seller.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Probable cause
Gas valve closed
Fuel used up
Opening clogged
Air in the gas hose system
Lose connections
Deposits on pilot flame
Lose connections
Defective heat sensor
Leaking gas line
Insufficient fuel pressure
Insufficient fuel pressure
Opening clogged
Control not on.
Defective heat sensor
Pilot light unit bent
Not in correct location
Item 63021
Solution
Open gas valve.
Refill fuel.
Clean or replace opening.
Let air out of the lines.
Re-tighten connections.
Clean contaminated areas.
Re-tighten connections.
Replace heat sensor.
Check connections.
Container almost empty; refill.
Container almost empty; refill.
Remove and clean.
Turn valve to On.
Replace heat sensor.
Properly place pilot light unit.
Position properly and retry.
Page 12
04
2021-1
Advertisement
