Advertisement
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety instructions
Caution:
If you smell gas:
Turn off the gas supply.
Extinguish open fire.
If the smell of gas persists, immediately notify the fire brigade.
Never store or use petrol or other highly flammable vapours and liquids near this device or
similar devices.
A disconnected liquid gas cylinder must not be stored near this device or comparable devices.
Only suitable for outdoor use or in very well ventilated areas. In such an area, at least a
quarter of its total surface must be open. The total surface of an area is the total of its wall sur -
faces.
Improper installation, adjustment, structural changes, maintenance, or care can cause prop-
erty damage or injuries. Read the assembly, operation, and maintenance instructions carefully
and completely before you start using the device.
The device and gas cylinder must be set up in accordance with the applicable regulations.
The ventilation slots in the gas cylinder housing must not be blocked.
The device must not be moved while being in operation.
Gas lines and hoses must be replaced within the prescribed periods.
Only gas and gas cylinders corresponding to the manufacturer's instructions may be used.
The liquid gas tank used together with the heater must have the following dimensions:
31.8 cm in diameter by 58 cm in height with a maximum capacity of 15 kg.
In strong winds, special care must be taken to ensure that the heater cannot fall over. The dis-
tance between the device and the gas cylinder must be at least 1 m.
The injector of this device cannot be removed, it is only connected at the factory. It is forbid -
den to modify the device in such a way that it works at a pressure other than the set pressure.
Do not connect the gas cylinder directly to the device without interposing a pressure reducing
valve. Use only the gas and the type of gas cylinder specified in the instructions.
The pressure reducing valve must match the respective device type in accordance with DIN
EN16129:2013 and national standards:
◦ A 30 mbar pressure reducing valve is used for butane/propane of category I3BP(30).
◦ A 30 mbar pressure reducing valve is used for butane of category I3+ (28–30/37).
◦ A 37 mbar pressure reducing valve is used for propane of category I3+ (28–30/37).
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 63021
Page 3
04
2021-1
Advertisement
