To Set Up The Controller Through The Service Port; Modstat Tab - Carrier TruVu UC683T Installation And Startup Manual

Table of Contents

To set up the controller through the Service port

You can communicate with the TV-UC683T through a web browser by connecting a computer to the controller's

Service Port using either the Carrier wireless service adapter or a USB cable.

NOTE You cannot access the Service port by plugging an Ethernet cable into Eth0 or Eth1.

Once you are connected to the network, you can:

•

Access the controller setup pages

•

Address and configure controllers

•

View the controller's Module Status report

•

View/change controller and network settings. Changes take effect immediately.

•

Troubleshoot

•

Use BACnet/Service port to access the i-Vu® application or a touchscreen device. See To communicate

through a BACnet/Service port network (page 46).

To access the controller setup pages and use the Local Network tab, you must first connect to and manually

address one TV-UC683T. For instructions on connecting, see Addressing the TV-UC683T through the Service port

(page 9). Navigate to http://local.access or http://169.254.1.1 to access the pages. Then set up the address on

your selected TV-UC683T on the Ports tab (page 48).

NOTE The first time you access the controller in the i-Vu® interface, after you have changed settings through the

Service port, be sure to upload the changes to the system database. This will preserve those settings when you

download memory or parameters to the controller.

This tab provides the controller's Module Status report that gives information about the controller and network

communication status. See Appendix - Module Status field descriptions (page 66).

TruVu™ UC683T

Installation and Start-up Guide

Table of Contents