Communication Status; Flow Calibration Archive - Carrier TruVu UC683T Installation And Startup Manual

Table of Contents

Adjusting the TV-UC683T driver properties

Communication Status

The Communication Status page shows the status of the protocols currently running on the TV-UC683T's ports.

Standalone Controller Detection

You can use the fields on this page with a binary input in your control program to detect when the controller does

not receive a write request from the selected network within the specified amount of time. The input remains OFF

as long as write requests are received, but switches to ON if the controller does not receive a request within the

specified time. The binary input must have the Expander number and Input number set to 99 and the I/O Type set

to Special.

Modbus Serial, Modbus TCP/IP, and Modbus Error Definitions pages

If the controller will be used with Modbus devices, see the Modbus Integration Guide for information on using

these pages.

NOTE This driver property only applies to controllers with built-in airflow sensors.

The Flow Calibration Archive page shows measured flow and sensor readings that were entered in the i-Vu® Test

and Balance tool or through the stand-alone Test & Balance Utility.

TruVu™ UC683T

Installation and Start-up Guide

Table of Contents