To Adjust Input And Output Properties - Carrier TruVu UC683T Installation And Startup Manual

To adjust input and output properties

To adjust input and output properties
An input or output must be assigned to its corresponding point in the control program. This is typically done when
the control program is created, but you can adjust the settings at the time of installation in the i-Vu® interface.
In the i-Vu® navigation tree, select the equipment controlled by the TV-UC683T.
1
On the Properties page, select the I/O Points tab.
2
In each point's Num field, type the number of the controller's corresponding input or output. For example, if
3
you use UO1 on the TV-UC683T for the point Pump S/S, type 1 in the Num field for Pump S/S.
NOTES
•
Exp (expander number) is 00 for the inputs and outputs located on the TV-UC683T.
•
Do not assign the same output number to more than one point.
Enter the appropriate values for each input and output in the remaining columns. See Input values, Output
4
values, Resolution values and Offset/Polarity values below.
If you have not performed the initial download to the attached controller, you must download now to verify
5
inputs and outputs.
To verify each input's operation, force each sensor to a known value, then compare it to the Value shown on
6
the Properties page on the I/O Points tab.
To verify each output's operation, lock each output to a known condition on the I/O Points tab, then verify
7
that the equipment operates correctly.
See Troubleshooting inputs and outputs (page 60).
TruVu™ UC683T
Installation and Start-up Guide
28
CARRIER CORPORATION ©2021
All rights reserved