To Revert To Default Settings - Carrier TruVu UC683T Installation And Startup Manual

To replace the fuse:
Remove the red power connector.
1
On both ends of the TV-UC683T, insert a small flathead screwdriver as shown below, and then gently pry up
2
the cover until it is released from the base.
Remove the cover from the base.
3
Remove the blown fuse.
4
Snap the new fuse into the fuse holder.
5
Replace the TV-UC683T's cover.
6
Replace the power connector.
7
Verify the
8

To revert to default settings

WARNING This erases all archived information and user-configuration settings. When recovery is complete,
you have to reconfigure all custom settings. You must connect locally to the TV-UC683T and manually reconfigure
all the communications and firewall information. We highly recommend that you revert the defaults settings only
under the guidance of Carrier Control Systems Support.
To erase volatile memory data and restore factory default configuration settings, use AppLoader to download the
appropriate clipping.
See the AppLoader User Guide for details.
TruVu™ UC683T
Installation and Start-up Guide
LEDs on the TV-UC683T are lit.
63
Troubleshooting
CARRIER CORPORATION ©2021
All rights reserved