Led Lighting; Controlling; About The User Interface - Electrolux ETE4607 User Manual

2. Before you remove the ice carriage, remember to
disengage it from the glass shelf as it may result in
damage to the assembly.
3. Remove the centre runner by disengaging it at the
front of the shelf, and removing it from the rear.
Insert into the slot at the rear of the shelf
4. Refit the runner into the rear of the shelf on the right
hand side and then engage the front.
5. Fit the carriage by sliding it into the runners until the
front if the carriage engages with the shelf.
6. Refit the ice tray and ice bin.
WARNING
Fill the ice cube tray with potable water only.
CAUTION

LED lighting

Your appliance is fitted with long life LED lighting.
In the unlikely event the LED lights should fail,
then the LED lights should be serviced by the
manufacturer.
Refer to the warranty page for contact details.
Then engage into the front of the shelf

CONTROLLING

ABOUT THE USER INTERFACE

The following pages explain the various functions of the
user interface to help you better understand how to get the
most out of your new refrigerator.
IMPORTANT
NOTE: When you set a temperature, you set an
average temperature for the whole refrigerator
cabinet. Ensuring that you make only small
adjustments and wait at least 24 hours to see if the
new temperature is correct to your liking.
Checking the softness of ice cream is a good indication
that your freezer is the right temperature, while checking
the temperature of water kept in the refrigerator is a good
way of checking the temperature of the food compartment.
Temperatures inside each compartment may vary,
depending on how much food you store and where you
place it.
High or low room temperature may also affect the actual
temperature inside the refrigerator.
17