Fitting The Handles; Ice & Water Models - Electrolux ETE4607 User Manual

5. If you find your refrigerator rocks from corner to
corner, it means your floor is uneven. Find a piece
of plastic or hardboard etc. and pack it firmly under
the roller.
6. You may now need to fine-tune the installation by
repeating steps 3, 4 and 5.
7. When you have the appliance in its final position, it
needs to be stabilised. Wind the stability foot under
the door hinge down to the floor until it just makes
contact with the floor. Lift the front of the appliance
to take the weight off the stability foot, then turn it
half a turn further to ensure firm contact with the
floor. Wind the large height adjusting nut back up to
ensure all the weight is now on the front stability foot.
8. Repeat step 7 for the stability foot on the handle
side. Whenever you need to move the appliance,
be sure to wind the feet back up so that the
appliance can roll freely and be sure to reset it
when reinstalling.
Large height
adjusting nut
wound up.
9. Plug your refrigerator straight into its own power
point and never use a double adapter. If you need
to roll the refrigerator to get to the plug, remember
to raise the stability foot first.
10. Before you put any food in your refrigerator, it's
recommended you leave it on for 2 or 3 hours to
check it is running properly.

FITTING THE HANDLES

For models with 'Pole' handles, the handles are supplied
prepackaged with your refrigerator and will require fitting.
Refer to the instructions provided in the pack.
Congratulations! You have successfully installed your
new refrigerator.
stability foot
wound down
ICE AND WATER MODELS
WARNING
Connect to potable water supply only, if using tank
or bore water in a model with an internal filter it is
recommended to also use an external filter
(not supplied).
The new hose sets supplied with the appliances
must be used and old hose sets should not
be reused.
Never connect the appliance to a hot water supply.
WATER FILTER
It should not be used on water that is micro biologically
unsafe or with water of unknown quality. The service life of
the filter may be reduced in water supplies that contain an
excess of particles or other impurities. Reduced flow rate is
an indication that a new filter is required. Failure to replace
the filter when required can affect the function of the ice
maker. Service calls caused by a failure to replace the filter
are not covered by warranty. Replacement water filters
are available from Electrolux Home Products Spare Parts
Centres and can be posted to you for your convenience
(refer to spare parts contact numbers on the warranty page).
Contents of installation kits
Filter Kit for single door freezer
1 x water filter with push fit connections
DATE FITTED___/___/___
2 x mounting brackets and screws
4 + 1 metres of water tubing
1 x 1/2" tap fitting
2 x circlips
Water supply and plumbing
A drinkable water supply to suit a 1/2" tap fitting is
required adjacent to the refrigerator. It is recommended
that a licensed plumber install a new water supply outlet
nearer to the appliance should the tubing supplied not be
long enough. It is not recommended that the tubing be
extended as this could adversely affect the flow of water
to the ice maker or water dispenser. The water dispenser
and automatic ice maker require a drinkable water supply
with a pressure range of between 206kPa and 689kPa
(30PSI and 100PSI). If the water supply is above 100psi a
pressure limiting valve should be installed.
Installation Kit
Bottom mount &
single door all refrigerator)
4 metres of water tubing
1 x 1/2" tap fitting
11