Output Connections To Multimeter - Keithley 2000-SCAN-20 Instruction Manual

2-16 Card Connections and Installation

Output connections to multimeter

After installation, connect the scanner card output leads to the multimeter rear panel jacks as
follows:
WARNING
For 2-pole operation, connect OUT A HI (red) to INPUT HI and connect OUT A LO (black)
to INPUT LO. See
NOTE
Figure 2-10
2-pole output connections
Input LO
Signals applied to the front inputs of the multimeter cannot exceed the
ratings of the scanner card as long as the scanner card output leads are
connected to the multimeter rear panel input jacks.
Figure 2-10.
Be sure to select the rear inputs with the multimeter front panel INPUTS switch when
using the scanner.
Out A
LO (Black)
Out A
HI (Red)
Input HI