锐捷以太网交换机快速安装指南 Ruijie Ethernet Switches Installation Quick Start 本指南适用于 RG-ES08 和 RG-ES08G,执行标准:GB 4943.1-2011 GB/T 9254-2008。 This quick start applies to RG-ES08 and RG-ES08G, the execution standards include GB 4943.1-2011 and GB/T 9254-2008. 1 设备安装 Install the Device 安装到墙壁 Wall Mounting 第一步:根据交换机底部的槽位,在墙上定位并钻孔,两边各自拧入一颗 M3 螺丝(自备) 。留出螺丝头用...
Page 3
安装到桌面 Desktop Mounting 将交换机正面朝上置于足够大且平稳的桌面上即可。 Place the switch upside down on a stable and flat desktop. 2 设备连接 Connect the Device 请根据您的组网需求,参照常见场景 a 或 b 进行设备连接。 Refer to scenario A or B for networking guidance based on your actual situation.
Page 5
Warning This is a Class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. 请参考下表检查设备连接是否正确。正确完成连接后,交换机无需进行任何设置即可使用。 Refer to the following table to check whether the device connection is correct. The switch can work immediately only after correct connection.
Page 6
The switch is disconnect from or not connected to a power supply properly. Solid on The port is connected properly. Blinking Data is being transmitted over the port. The port is disconnected or not connected properly.
Page 7
如需了解产品及安装方面的更多信息,请登陆锐捷网络网站 www.ruijie.com.cn For more information about the product and installation procedures, log in to www.ruijie.com.cn 锐捷网络股份有限公司 版权所有,保留一切权利 Copyright @ ruijie networks Co., Ltd.
Need help?
Do you have a question about the RG-ES08 and is the answer not in the manual?
Questions and answers