Programming; Using Programming Barcodes; Configure Other Settings; Resetting Standard Product Defaults - Datalogic GBT4100 Quick Reference Manual

Programming

Programming
The reader is factory-configured with a set of standard
default features. After scanning the interface barcode
from the Interfaces section, you can select other options
and customize your reader through use of the instructions
and programming barcodes available in the Gryphon™ I
Product Reference Guide (PRG). Check the corresponding
features section for your interface, and also the Data Edit-
ing and Symbologies chapters of the PRG.

Using Programming Barcodes

This manual contains barcodes which allow you to recon-
figure your reader. Some programming barcode labels, like
the "Standard Product Default Settings" on page 31,
require only the scan of that single label to enact the
change.
Other barcodes require the reader to be placed in Pro-
gramming Mode prior to scanning them. Scan an ENTER/
EXIT barcode once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT barcode
again to accept your changes, which exits Programming
Mode and returns the reader to normal operation.

Configure Other Settings

Additional programming barcodes are available in the Gry-
phon™ I PRG to allow for customizing programming fea-
tures. If your installation requires different programming
than the standard factory default settings, refer to the
PRG.

Resetting Standard Product Defaults

Reference the PRG for a listing of standard factory set-
tings. If you aren't sure what programming options are in
your reader, or you've changed some options and want the
factory settings restored, scan the
Settings barcode below to copy the factory configuration
for the currently active interface to the current configura-
tion.
30
Factory defaults are based on the interface
type. Configure the reader for the correct inter-
face before scanning this label.
Standard Product Default
Gryphon™ I GBT4100