Magnescale LH70 Quick Start Manual

LH70 Change of display resolution (polarity)
The operation method for changing the display resolution differs depending on the purpose and conditions of the change.
Select the purpose and conditions to be changed from the table below and perform the operation.
Purpose of change
Change the measurement unit resolution
Change the polarity for each input axis
while using the addition function
Change the display resolution
Change the display polarity
(Counting direction is reversed)
Diameter display (double count value)
* If you do not know the output resolution of the measurement unit, refer to the separate "Initial setup manual".
Basic settings ⇒ Measurement unit resolution ⇒ Change
①
Set to basic settings mode.
Turn key "ON" while the AC adapter is energized.
Press and hold key for 3 seconds after the lamp changes from blinking to off.
For LH70-1, LH70-2
Power ON
②
Press key once while the display is
The display will be
Press key to check the current measurement unit resolution.
③
Press key of the axis you want to change and select
the measurement unit resolution.
When you have made your selection, press
④
Switch from basic settings to normal count mode.
Press key once and the display will change to
Press key once and the display will change to
⑤
Press key once to automatically switch to advanced settings mode.
The display will be
Press key, the display becomes the normal display.
Operation
Basic settings ⇒ Measurement unit resolution ⇒
Change
Basic settings ⇒ Addition display ⇒ Change
Detailed settings ⇒ Display resolution ⇒ Change
Detailed settings ⇒ Display resolution ⇒ Change polarity
Detailed settings ⇒ Display resolution ⇒ Diameter display
About 2 sec
.
(measurement unit resolution).
key to save your settings.
.
.
LH70 Change of display resolution (polarity)
②
Press key two or three times while the display is
The display will be
Press key to check the current length measurement unit resolution.
Display of measurement unit resolution (LH70-3)
Input 1
Input 2
Input 3
.
Explanation
Change the length measurement unit resolution in
the basic settings. And check the display resolution
in the detailed settings.
Change the selection of addition display in the basic
settings
Change the display resolution in the detailed
settings
Change the display resolution in the detailed
settings
Change to diameter display with display resolution
in the detailed settings
LH70-3
For LH70-3
About 2 sec
(measurement unit resolution).
Selection of measurement
unit resolution
Standard
Ver.1 (2021.1) CS&S
.
Expansion
Extended key
1/3