Table of Contents
Advertisement
Handset does not ring
•
Make sure the handset ringer software switch is set to on.
•
The handset may be out of range of the base. Move closer to the base.
•
You may have too many extension phones on your line. Try unplugging some extension phones.
•
Check for a dial tone.
You experience static, noise, or fading in and out
•
The handset may be out of range of the base. Move closer to base.
•
Make sure base is not plugged into an electrical outlet with another household appliance. If
necessary, relocate the base.
•
Charge the battery (for 16 hours).
Unit beeps
•
Clean the charging contacts on
an eraser.
•
See solutions for "No dial tone " on previous page.
•
Replace the battery.
Memory dialing doesn't work
•
Did you program the memory location keys correctly?
•
Did you follow proper dialing sequence?
Unit locks up and no communication between the base and cordless handset
•
Unplug the
AC power adapter
handset battery. Wait for 30 seconds and plug the
electrical outlet. Reconnect the battery and charge for 16 hours.
Charge Indicator on the Base Flashes
•
Provided your phone company offers voice messaging service and you subscribe to it, the charge
indicator on the base flashes when the phone is not in use to indicate there is a message waiting.
It's stops flashing after the message has been reviewed.
Docking Station Solutions
Cannot make or receive cell phone calls through the cordless handset.
•
Make sure the docking station is connected to a non-switched electrical outlet. Disconnect the
AC power adapter from the docking station and reconnect it.
•
Make sure the adapter cable is firmly attached to both the cell phone and the docking station.
Disconnect the adapter cable from the docking station and the cell phone. Re-attach the adapter
cable to the docking station, and connect the cell phone to the other end of the adapter cable.
The docked indicator should come on.
the cordless handset
from the electrical outlet and the back of the base. Remove the
and base charge cradle with a soft cloth or
AC power adapter
back into the base and
Troubleshooting
41
Advertisement
Table of Contents
