Troubleshooting
PAGING or
PAGING FROM
BLOCKED NUMBER
REPT
NO CALLS
NO DATA
NEW CALL XX
LOW BATTERY
LONG DISTANCE
Handset Sound Signals
Signal
A long warbling tone (with ringer on)
Three short beeps
One short beep (every 7 seconds)
Troubleshooting Guide
Telephone Solutions
No dial tone
•
Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall jack.
•
Connect another phone to the same jack. If it doesn't work, the problem might be your wiring or
local service.
•
The handset may be out of range of the base. Move closer to the base
•
Make sure the battery is properly charged (for 16 hours).
•
Make sure the battery pack (in the handset) is properly installed.
•
The handset should beep when you press the home button or cell button, and the charge
indicator on the base should be lit when the handset rests in the cradle. If not, the battery
may need to be charged.
•
Place handset in charge cradle for at least 20 seconds to reset the unit.
40
Someone pressed the page/int button on the base or handset.
Indicates the person is calling from a number which is blocked from
transmission.
Indicates a repeat call message. Indicates a new call from the same
number was received more
than once.
Indicates there are no CID records in memory.
Indicates no CID information was received , you are not subscribed to
CID service, or CID service is not working.
XX represents the number of new CID records not reviewed.
Indicates the battery needs to be charged.
Indicates CID record is from a long distance call.
Meaning
Signals an incoming call
Page signal
Low battery warning