Installing The Dockings; Attery - RCA 23200 User Manual

Connections & Setup
Installing the Handset Battery
NOTE: You must connect the handset battery before use.
1. Push down on the top of the battery compartment cover (located on the back of each handset)
and remove the cover.
2. Plug the battery pack cord into the jack inside the battery compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the
compartment. To ensure proper battery installation, the connector is keyed and can be inserted
only one way.
3. Insert the battery pack.
4. Close the battery compartment by pushing the door up until it snaps into place.
5. Place the handset in the charging cradle.
Allow handset to charge for 16 hours prior to first use. If you don't properly charge the
handset, battery performance is compromised.
NOTE: If the battery is not properly installed in the handset, or if the battery pack is not properly
connected to the jack inside the battery compartment. "NO BATTERY" shows in the display when
the handset is placed in the charging cradle.
Installing the Docking Station
NOTE: Prior to
Choose the best location to install the docking station, it should be placed on a level surface such as
a desk or table top.
1. Plug one end of the docking station power adapter cord into the power jack on the back of the
docking station and the other end into an electrical outlet. Docking station display will show
DOCKING STATION REGISTERED after a few seconds.
10
PRESS DOWN
FIRMLY
RED WIRE
installing the docking station, make sure the base unit has been installed.
BATTERY
BLACK WIRE