Description Of The Controls - Hyundai CON 100 Instruction Manual

• Ensure the power supply to the socket into which the heater is plugged is in accordance with
the rating label on the heater and that the socket is earthed.
• Keep the mains lead away from the hot body of the heater.
• The heater is not intended for use in bathrooms, laundry areas or similar indoor locations.
• Never place the heater where it may fall into a bathtub or other water container.
• Do not cover or obstruct any of the heat outlet grilles or the air intake openings of the heater.
• Do not place the heater on carpets having a very deep pile.
• Always ensure that the heater is placed on a firm level surface. Ensure that the heater is not
positioned close to curtains or furniture as this could create a fire hazard.
• Do not position the heater in front of, or immediately below, a wall socket.
• Do not insert any object through the heat outlet or air intake grilles of the heater.
• Do not use the heater in areas where flammable liquids are stored or where flammable fumes
may be present.
• Always unplug the heater when moving it from one location to another.
• Do not place the unit just below the socket.
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on
after having not been used for a long period of time the heaters may emit some smell
and fumes. This will disappear when the heater has been on a short while.

DESCRIPTION Of THE CONTROLS

P1. Holder for transport
P2. Fan switch
P3. Power switches
P4. Thermostat
P5. Feet
INSTRUCTIONS fOR USE
Assembly of the heater (while use on the floor as portable appliance). Before using the heater,
the feet (supplied in the carton), must be fitted to the main unit. These are to be attached to the
base of the heater using the 4 self-tapping screws provided, taking care to ensure that they are
located correctly in the bottom ends of the heater side mouldings
Operation of the heater
1) Choose a suitable location for the heater, taking into account the safety instructions above.
2) Insert the plug of the heater into a suitable socket.
3) Turn the thermostat knob fully in a clockwise direction to the maximum setting.
4) Turn on the heating elements by the power switches on the side panel. For maximum heat
output turn both switch to ON.
Change of wattage:
Both switches OFF
First switch ON
Seconf switch ON
Both switches ON
OFF
750 W
1250 W
2000W
ENG - 17
ENG