Table of Contents
Advertisement
4-5-2 Linearity adjustment
(Guide roller S, T adjustment)
1. Playback the Mono Scope alignment tape
(SP mode).
2. Observe the video envelope signal on an
oscilloscope (triggered by the video switching
pulse).
3. Make sure the video envelope waveform
(at itsminimum) meets the specification shown in
Fig. 4-5-7.
If it does not, adjust as follows :
Note :
a=Maximum output of the video RF envelope.
b=Minimum output of the video RF envelope at the
entrance side.
c=Minimum output of the video RF envelope at the
center point.
d=Maximum output of the video RF envelope at the
exit side.
4. If the section A in Fig. 4-5-8 does not meet the
specification, adjust the guide roller S up or
down.
5. If the section B in Fig. 4-5-8 does not meet the
specification, adjust the guide roller T up or
down.
6. Play back the Mono Scope alignment tape (SP mode).
7. Connect an oscilloscope CH-1 to the Envelope and CH-2 to the HÕD SW Pulse for triggering.
8. Turn the guide roller heads with a flat head (
Fig. 4-5-9.
Samsung Electronics
S HEIGHT
TOO HIGH
GUIDE ROLLER S
Fig. 4-5-9 Guide Roller S, T Height Adjustment
b
Fig. 4-5-7 Envelope Waveform Adjustment
H'D SWITCHING
PULSE
ENVELOPE
) driver to obtain a flat video RF envelope as shown in
IDEAL ENVELOPE
S HEIGHT
T HEIGHT
TOO LOW
TOO HIGH
Alignments and Adjustments (Mechanical)
a
c
a b c d
63%
c,b,d/a
A
B
A
B
Fig. 4-5-8 Adjustment Points
T HEIGHT
TOO LOW
GUIDE ROLLER T
d
4-23
Advertisement
Table of Contents
