Samsung TW14C52S/BWT Service Manual page 28

4-2-28 Motor Capstan Ass'y Removal
1. Remove the 3 Screws Œ.
2. Remove the Motor Capstan AssÕy ´.
Assembly :
1. Match the 3 holes of Motor Capstan AssÕy ´ to
the 3 holes of Main Base as attending not to drop
or knock the Motor Capstan AssÕy.
2. Tighten the 3 Screws in the direction of arrow as
shown detail drawing.
Note :
1. DonÕt reuse the removed screws from Motor
Capstan AssÕy.
2. After tightening screws, check if there is gap
between the head of screws and the top side of
Main Base. There should have no gap between
the head of screws and the top side of Main Base.
3. After reinstalling, adjusting the tape transport
system again.
´ MOTOR CAPSTAN ASS'Y
Fig. 4-31 Motor Capstan Ass'y Removal
Samsung Electronics
4-2-29 How to Manually Eject the Cassette Tape
1. Remove the Holder worm Πand the Gear Worm
´.
2. Turn the Gear Worm Wheel ˇ counterclockwise
with screw driver. (Refer to arrow)
Π3 SCREWS
C
3. As Sliders S and T are approched in the
A
unloading position, rotate holder Clutch counter-
B
clockwise after inserting screw driver in the hole
of frameÕs bottom (in order to wind the unwinded
<DETAIL>
tape). (Refer to Fig. 4-33)
If you rotate Gear Worm Wheel continuously
when tape is unwinding, you may cause tape
contamination by grease and tape damage. Be
sure to wind horizontally.
4. Rotate Gear Worm Wheel ˇ counterclockwise
using screw driver, up to the state of eject mode,
and then pick out the tape.
(Refer to Fig. 4-32)
Alignments and Adjustments (Mechanical)
ˇ GEAR WORM WHEEL
´ GEAR WORM
ΠHOLDER WORM
Fig. 4-32
FRAME
Fig. 4-33
SCREW DRIVER
4-17