Installing The Cap Over The Speaker/ Microphone Jacks - Kenwood TK-D348R User Manual

INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE
JACKS
Install the cap over the speaker/ microphone jacks when not using an optional
speaker/ microphone or headset.
Note:
◆ To keep the transceiver water resistant, you must cover the speaker/ microphone jacks
with the supplied cap.
1 Place the cap over the jacks so that the locking tabs insert into the
transceiver grooves.
2 While holding the cap in place, push it towards the bottom of the
transceiver until the tabs on the cap click into place.
• To remove the cap, hold the top of the cap in place with your finger while
inserting a 2 mm or smaller flat blade screwdriver under the bottom of the
cap. Slowly slide the screwdriver in until its tip touches the tab inside the
cap, then gently pry the cap up (handle of screwdriver moving away from the
transceiver) to remove the cap.
6