Installing The Cap Over The Speaker/ Microphone Jacks; Installing The Speaker/ Microphone Or Headset - Kenwood NX-1208N User Manual

INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE JACKS

Note:
◆ For the speaker/ microphone jack, waterproof performance is guaranteed by
securing the supplied cap. Waterproof performance will not be guaranteed by
connecting an optional speaker/ microphone, etc.
◆ Use the Phillips #1 screwdriver.
1 If you are not using an optional speaker/
microphone or headset, install the cap over the
speaker/ microphone jacks.
2 Secure the cap in place using the attached screw.

INSTALLING THE SPEAKER/ MICROPHONE OR HEADSET

Note:
◆ The transceiver is not fully water resistant when using a speaker/ microphone
or headset.
◆ Use the Phillips #1 screwdriver.
1
Insert the speaker/ microphone plugs into the
speaker/ microphone jacks of the transceiver.
2
Place the locking bracket over the speaker/
microphone plugs so that the locking tabs insert
into the transceiver grooves.
3
Secure the locking bracket in place using the
attached screw.
Speaker/ microphone
jack cap
Speaker/ microphone
locking bracket
8
Screw
Screw