Range Installation; Check Operation; Leveling The Range - Frigidaire GLCS376CSA Installation Instructions Manual

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

8. Range Installation

When unpacking the range, do not
discard the 4 shipping bolts. These are to be replaced
on the unit for use as leveling legs and height
adjustments.
1. Installation Without Side Panel(s)
A. The range cooktop overlaps the countertop at
the sides and the range rests on the floor. The
cooktop is 30" (76.2 cm) wide.
B. Install base cabinets 29" (73.7 cm) apart. Make
sure they are plumb and level before attaching
cooktop. Shave raised countertop edge to clear
30" (76.2 cm) wide range top rim.
C. Install cabinet doors 31" (78.7 cm) min. apart so
as not to interfere with range door opening.
D. Cutout countertop exactly as shown on page 1.
E. A backguard kit can be ordered through your
dealer.
F. Adjust leveling legs so that the underside of the
cooktop is sitting on the countertop.
G. Level the range. The floor where the range
is to be installed must be level (see
Figure 11).
2. Installation With Side Panel(s)
A. Install base cabinets 30
apart. Make sure they are plumb and level.
B. Install cabinet doors 31" (78.7 cm) min. apart so
as not to interfere with range door opening.
c. A backguard kit can be ordered through your
dealer.
D An end panel kit can be ordered through your
dealer.
E. Level the range and adjust cooktop height.
3. Installation With Backguard
5
The cutout depth of 21
/
increased to 24" (61 cm) when installing a backguard.

9. Leveling the Range

Level the range and set cooktop height before
installation in the cut-out opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack. Take 2 readings with the
level placed diagonally in one direction and then the
other. Level the range, if necessary, by adjusting the
4 leg levelers with a wrench (see Figure15).
3. Taking care to not damage the countertop, slide
range into cut-out opening and double check for
levelness. If the range is not level, pull unit out and
readjust leveling legs, or make sure floor is level.
(Models with an Electric Oven and a Gas Cooktop)
1
" (76.5 cm) min.
/
8
" (55 cm) needs to be
8

10. Check Operation

Refer to the Owner's Guide packaged with the range for
operating instructions and for care and cleaning of your
range.
Do not touch the elements or burners.
They may be hot enough to cause burns.
Remove all packaging from the oven before testing.
1. Install Burner Bases and Burner Caps
This range is equipped with sealed burners as shown
(see Figure 12).
Burner
Cap
Burner
Base
Burner
Pan
Electrode
A. Unpack burner bases and burner caps.
B. Place burner bases over each gas opening.
C. Make sure the burner is properly aligned and
leveled. Place burner caps over appropriate
burner bases.
NOTE: There are no burner adjustments necessary on
this range.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power.
9
Figure 11
Gas
Opening
Figure 12