Yamaha Venture Lite PZ50RTB Owner's Manual page 58

Periodic maintenance and adjustment
1. Top cover
To install the top cover
Insert the projections on the front of the top
cover into the slots in the left and right upper
covers, and then fit the projections on the rear
of the top cover into the grommets.
Right upper cover (PZ50RT / PZ50GT /
PZ50MT)
To remove the right upper cover
1. Remove the top cover. (See the above
procedure.)
2. Remove the right upper cover by remov-
ing bolts A and bolt B.
1. Right upper cover bolt A
2. Right upper cover bolt B
3. Right upper cover
To install the right upper cover
1. Place the right upper cover in the original
position, and then install and tighten bolts
A and bolt B to their specified torques.
52
Tightening torques:
2.
Left and right upper covers (PZ50VT)
To remove an upper cover
1.
2.
1. Fastener
2. Left upper cover
To install an upper cover
1.
3
2
1. Projection
2. Holder
Right upper cover bolt A:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
Right upper cover bolt B:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
Install the top cover.
Open the shroud. (See the above proce-
dure.)
Loosen the fasteners, and then remove
the upper cover.
Insert the projections on the upper cover
into the slots, fit the holders on the cover
onto the grommets, and then tighten the
fasteners.