V-Belt Holder (Pz50Vt); Passenger Grip Warmer Switch (Pz50Vt) - Yamaha Venture Lite PZ50RTB Owner's Manual

1. Drive guard locking pin
2. Drive guard
2. Slightly raise the front of the drive guard,
and then lift up the drive guard to remove
it.
To install the drive guard
1. Fit the slots in the rear of the drive guard
onto the projections on the drive guard
rear holder.
1. Drive guard
Control functions
2. Align the slots in the top of the drive guard
with the projections on the drive guard
upper holder, and then insert the drive
guard locking pin into the holder.
ESU10770

V-belt holder (PZ50VT)

Keep a spare V-belt for emergency use by
placing it into the V-belt holder provided.
1. V-belt holder
ECS00190
NOTICE
Make sure that the V-belt is installed se-
curely in the holder.
ESU10681
Passenger grip warmer switch
(PZ50VT)
The passenger grip warmer switch controls
the electrically heated passenger grips.
1. Passenger grip warmer switch
2. Off
3. "HI" (high)
4. "LO" (low)
21