Idis DA-FM1500 Installation Manual

DA-FM1500 INSTALLATION MANUAL
Mounting
1
Assemble the camera body to the bracket by
tightening the screws.
• DC-D3233WRX / DC-D3233RX / DC-D3233X Models:
Screw No. 5 (3-point), PCB Support 8.8mm
• DC-D4233WRX / DC-D4233HRX / DC-D4223WRX
Models: Screw No. 5 (3-point), PCB Support 8.8mm
6ea
• DC-D4233RX / DC-D4223RX Models: Screw No. 4
(2-point), PCB Support 8.8mm 4ea
• TC-D4222WRX / TC-D4221WRXP Model: Screw
No.6(2-point), No PCB support necessary
• TC-D4222RX / TC-D4221RXP Model: Screw NO.6(2-
point), PCB support 8.8mm
• Other Plastic Dome Models: Screw No. 2 (3-point), No
PCB support necessary
• Other Vandal Dome Models: Screw No. 1 (3-point),
No PCB support necessary
2
Connect the cable through the cable hole
and screw the safety wire to the bracket to
prevent the bracket from falling on to the
floor.
This manual is intended for the users of the DA-FM1500 ceiling mounting
bracket. It includes the instructions for mounting the DA-FM1500 ceiling
mounting bracket to the ceiling.
• This bracket is intended to be used with some models of dome
cameras. Ask your retailer for details on a specific model and do
not use it with other models of cameras.
• This installation should be performed by a qualified service
personnel in conformance to all local codes.
• You may need to reinforce the ceiling. If the ceiling is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
< Screw No. >
(DC-D4233RX Model)
*When using the screws of DC-D4233RX / DC-D4223RX /
DC-D4233WRX / DC-D4233HRX / DC-D4223WRX models,
combine the two as shown below.
Cable
Safety Wire