Idis DA-JB4600 Installation Manual

DA-JB4600 INSTALLATION MANUAL
Mounting: DC-D4213WRX, DC-D4513WRX
1
Mount the bracket to the wall by using the
screws.
2
Insert cables from external devices, network
and power adapter.
3
Pass the cable through the top cover, insert the
waterproof bushing provided with the product
into the cable and insert it into the top cover
hole as the figure.
• Cable diameters that can be fastened to the bushing
are 4-6mm(0.15"-0.23"), and other sizes require a
separate sealing finish.
• Bushings that do not tighten cables and unused holes
require a separate sealing finish.
4
Fasten the top cover and the body.
5
Connect the cable to the camera and screw the
camera onto the top cover.
If the cable is bent too much when the camera is installed,
a separate sealing finish is required as the waterproof
function may be weakened.
6
Screw the camera dome cover onto the camera
body using the Allen wrench provided with the
product.
7
Turn on power.
Mounting: DC-Y6513WRX, TC-D4222WRX
1
Mount the bracket to the wall by using the
screws.
2
Insert cables from external devices, network
and power adapter.
This manual is intended for users of the DA-JB4600 junction box. It
includes instructions for mounting the DA-JB4600 junction box to a wall.
• This junction box is intended to be used with some models of
cameras. Do not use it with other models of cameras.
• This installation should be performed by a qualified service
personnel in conformance to all local codes.
• You may need to reinforce the wall. If the wall is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Bracket
Camera
Body
Camera
Dome
Cover